registry / dsh-remote / 0.1.2
dsh-remote@0.1.2
Remote-access assistant for DeepSeek Harness: /remote command and a settings page that print the exact SSH tunnel / reverse-tunnel / reverse-proxy commands for this instance (harness intentionally binds loopback only).
Static Scan Results
scanned 3mo ago · by rust-scannerStatic analysis completed at 65.0% confidence. No malicious behavior was detected; 3 low-signal pattern(s) were surfaced and cleared.
Static reason
No blocking static signals were detected.
Decision evidence
public snapshotBehavioral surface
Network
HighEntropyStringsUrlStrings
Source & flagged code
0 flaggedNo flagged code excerpts are attached to this scan.
Findings
1 Medium2 Low
MediumNetwork
LowHigh Entropy Strings
LowUrl Strings
Affected versions and remediation
This report applies to dsh-remote@0.1.2.
See all versions of dsh-remote for other recorded verdicts.
- Review the evidence and your use of dsh-remote@0.1.2 before allowing it. Restrict the permissions described in this report.
- Choose an independently verified alternative or release. This report does not establish that other versions are safe.
Evidence last updated: .
Think this verdict is wrong? Dispute it on GitHub or read how reports are produced.